mirror of
https://git.openwrt.org/openwrt/openwrt.git
synced 2024-11-22 13:06:14 +00:00
3aef61060e
Extreme Networks AP3935i/e - https://www.extremenetworks.com/support/documentation/access-points-ap3935i-e/ SoC: IPQ8068 QYY AT46279K45060I RAM: NANYA 1527 NT5CC256M16DP-DI 515073W0EF 7 TW FLASH: NOR - S25FL256S1 - 32MB NAND - Macronix MX30UF4G28AB - 512MB LAN: Atheros AR8035-A J5150WL 1515 CN - RGMII LAN2: Atheros AR8033-AL1A SKCSR.AJ1 1444 China - SGMII WLAN2: QCA9990 OVV FNPV209 K451406 WLAN5: QCA9990 OVV FNPV209 K451406 SERIAL: RS232 Port (115200 8n1) Cisco console cable and 4pin Serial Header | 3.3 | GND | RX | TX MAC address for LAN1/LAN2/WLAN 2G/WLAN 5G in uboot env * Installation via either RJ45 console or on-board 4 PIN header Install Method -------------- 1) Setup TFTP server, and place openwrt-ipq806x-generic-extreme_ap3935-initramfs-uImage image in /srv/tftp or similar 2) Connect to console on router and connect ethernet port "LAN1" to your LAN 3) Interupt the boot with any character 4) Login with admin/new2day for default password (use reset/FactoryDefault if password needs to be reset) 5) Set serverip to TFTP IP: set serverip 192.168.1.2 6) Set ipaddr to another IP: set ipaddr 192.168.1.101 7) Make uboot ping something to activate eth0 on boot: set bootcmd 'ping 192.168.1.1; run boot_flash' saveenv 8) TFTP image to RAM: tftpboot 0x42000000 openwrt-ipq806x-generic-extreme_ap3935i-initramfs-uImage 9) Boot image: bootm 0x42000000 In OpenWRT, "LAN1" is LAN, "LAN2" is WAN 10) SFTP openwrt-ipq806x-generic-extreme_ap3935-squashfs-nand-sysupgrade.bin image to /tmp 11) sysupgrade /tmp/openwrt-*-nand-sysupgrade.bin Signed-off-by: Glen Lee <g2lee@yahoo.com>
24 lines
365 B
Bash
Executable File
24 lines
365 B
Bash
Executable File
#!/bin/sh /etc/rc.common
|
|
|
|
START=99
|
|
|
|
. "$IPKG_INSTROOT/lib/upgrade/asrock.sh"
|
|
|
|
boot() {
|
|
case $(board_name) in
|
|
asrock,g10)
|
|
asrock_bootconfig_mangle "bootcheck" && reboot
|
|
;;
|
|
edgecore,ecw5410)
|
|
fw_setenv bootcount 0
|
|
;;
|
|
extreme,ap3935)
|
|
fw_setenv WATCHDOG_COUNT 0x00000000
|
|
;;
|
|
linksys,ea7500-v1 |\
|
|
linksys,ea8500)
|
|
mtd resetbc s_env || true
|
|
;;
|
|
esac
|
|
}
|