msm8916-openwrt/target/linux/bcm27xx/patches-6.6/950-0611-drm-vc4-crtc-Add-support-for-BCM2712-PixelValves.patch
Álvaro Fernández Rojas 8c405cdccc bcm27xx: add 6.6 kernel patches
The patches were generated from the RPi repo with the following command:
git format-patch v6.6.34..rpi-6.1.y

Some patches needed rebasing and, as usual, the applied and reverted, wireless
drivers, Github workflows, READMEs and defconfigs patches were removed.

Signed-off-by: Álvaro Fernández Rojas <noltari@gmail.com>
2024-06-18 18:52:49 +02:00

145 lines
5.0 KiB
Diff

From 43a1ac11991b1f4194c35826f7ce94bd0851e6f2 Mon Sep 17 00:00:00 2001
From: Maxime Ripard <maxime@cerno.tech>
Date: Fri, 17 Feb 2023 15:33:23 +0100
Subject: [PATCH 0611/1085] drm/vc4: crtc: Add support for BCM2712 PixelValves
The PixelValves found on the BCM2712 are similar to the ones found in
the previous generation.
Compared to BCM2711, the pixelvalves only drive one HDMI controller each
and HDMI1 PixelValve has a FIFO long enough to support 4k at 60Hz.
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
---
drivers/gpu/drm/vc4/vc4_crtc.c | 53 ++++++++++++++++++++++++++++++++--
drivers/gpu/drm/vc4/vc4_drv.h | 2 ++
drivers/gpu/drm/vc4/vc4_regs.h | 5 ++++
3 files changed, 58 insertions(+), 2 deletions(-)
--- a/drivers/gpu/drm/vc4/vc4_crtc.c
+++ b/drivers/gpu/drm/vc4/vc4_crtc.c
@@ -240,6 +240,11 @@ static u32 vc4_get_fifo_full_level(struc
const struct vc4_crtc_data *crtc_data = vc4_crtc_to_vc4_crtc_data(vc4_crtc);
const struct vc4_pv_data *pv_data = vc4_crtc_to_vc4_pv_data(vc4_crtc);
struct vc4_dev *vc4 = to_vc4_dev(vc4_crtc->base.dev);
+
+ /*
+ * NOTE: Could we use register 0x68 (PV_HW_CFG1) to get the FIFO
+ * size?
+ */
u32 fifo_len_bytes = pv_data->fifo_depth;
/*
@@ -394,6 +399,12 @@ static void vc4_crtc_config_pv(struct dr
vc4_crtc_pixelvalve_reset(crtc);
+ /*
+ * NOTE: The BCM2712 has a H_OTE (Horizontal Odd Timing Enable)
+ * bit that, when set, will allow to specify the timings in
+ * pixels instead of cycles, thus allowing to specify odd
+ * timings.
+ */
CRTC_WRITE(PV_HORZA,
VC4_SET_FIELD((mode->htotal - mode->hsync_end) * pixel_rep / ppc,
PV_HORZA_HBP) |
@@ -463,11 +474,17 @@ static void vc4_crtc_config_pv(struct dr
if (is_dsi)
CRTC_WRITE(PV_HACT_ACT, mode->hdisplay * pixel_rep);
- if (vc4->gen == VC4_GEN_5)
+ if (vc4->gen >= VC4_GEN_5)
CRTC_WRITE(PV_MUX_CFG,
VC4_SET_FIELD(PV_MUX_CFG_RGB_PIXEL_MUX_MODE_NO_SWAP,
PV_MUX_CFG_RGB_PIXEL_MUX_MODE));
+ if (vc4->gen >= VC4_GEN_6)
+ CRTC_WRITE(PV_PIPE_INIT_CTRL,
+ VC4_SET_FIELD(1, PV_PIPE_INIT_CTRL_PV_INIT_WIDTH) |
+ VC4_SET_FIELD(1, PV_PIPE_INIT_CTRL_PV_INIT_IDLE) |
+ PV_PIPE_INIT_CTRL_PV_INIT_EN);
+
CRTC_WRITE(PV_CONTROL, PV_CONTROL_FIFO_CLR |
vc4_crtc_get_fifo_full_level_bits(vc4_crtc, format) |
VC4_SET_FIELD(format, PV_CONTROL_FORMAT) |
@@ -566,7 +583,11 @@ int vc4_crtc_disable_at_boot(struct drm_
if (!(of_device_is_compatible(vc4_crtc->pdev->dev.of_node,
"brcm,bcm2711-pixelvalve2") ||
of_device_is_compatible(vc4_crtc->pdev->dev.of_node,
- "brcm,bcm2711-pixelvalve4")))
+ "brcm,bcm2711-pixelvalve4") ||
+ of_device_is_compatible(vc4_crtc->pdev->dev.of_node,
+ "brcm,bcm2712-pixelvalve0") ||
+ of_device_is_compatible(vc4_crtc->pdev->dev.of_node,
+ "brcm,bcm2712-pixelvalve1")))
return 0;
if (!(CRTC_READ(PV_CONTROL) & PV_CONTROL_EN))
@@ -1302,6 +1323,32 @@ const struct vc4_pv_data bcm2711_pv4_dat
},
};
+const struct vc4_pv_data bcm2712_pv0_data = {
+ .base = {
+ .debugfs_name = "crtc0_regs",
+ .hvs_available_channels = BIT(0),
+ .hvs_output = 0,
+ },
+ .fifo_depth = 64,
+ .pixels_per_clock = 2,
+ .encoder_types = {
+ [0] = VC4_ENCODER_TYPE_HDMI0,
+ },
+};
+
+const struct vc4_pv_data bcm2712_pv1_data = {
+ .base = {
+ .debugfs_name = "crtc1_regs",
+ .hvs_available_channels = BIT(1),
+ .hvs_output = 1,
+ },
+ .fifo_depth = 64,
+ .pixels_per_clock = 2,
+ .encoder_types = {
+ [0] = VC4_ENCODER_TYPE_HDMI1,
+ },
+};
+
static const struct of_device_id vc4_crtc_dt_match[] = {
{ .compatible = "brcm,bcm2835-pixelvalve0", .data = &bcm2835_pv0_data },
{ .compatible = "brcm,bcm2835-pixelvalve1", .data = &bcm2835_pv1_data },
@@ -1311,6 +1358,8 @@ static const struct of_device_id vc4_crt
{ .compatible = "brcm,bcm2711-pixelvalve2", .data = &bcm2711_pv2_data },
{ .compatible = "brcm,bcm2711-pixelvalve3", .data = &bcm2711_pv3_data },
{ .compatible = "brcm,bcm2711-pixelvalve4", .data = &bcm2711_pv4_data },
+ { .compatible = "brcm,bcm2712-pixelvalve0", .data = &bcm2712_pv0_data },
+ { .compatible = "brcm,bcm2712-pixelvalve1", .data = &bcm2712_pv1_data },
{}
};
--- a/drivers/gpu/drm/vc4/vc4_drv.h
+++ b/drivers/gpu/drm/vc4/vc4_drv.h
@@ -568,6 +568,8 @@ extern const struct vc4_pv_data bcm2711_
extern const struct vc4_pv_data bcm2711_pv2_data;
extern const struct vc4_pv_data bcm2711_pv3_data;
extern const struct vc4_pv_data bcm2711_pv4_data;
+extern const struct vc4_pv_data bcm2712_pv0_data;
+extern const struct vc4_pv_data bcm2712_pv1_data;
struct vc4_crtc {
struct drm_crtc base;
--- a/drivers/gpu/drm/vc4/vc4_regs.h
+++ b/drivers/gpu/drm/vc4/vc4_regs.h
@@ -215,6 +215,11 @@
# define PV_MUX_CFG_RGB_PIXEL_MUX_MODE_SHIFT 2
# define PV_MUX_CFG_RGB_PIXEL_MUX_MODE_NO_SWAP 8
+#define PV_PIPE_INIT_CTRL 0x94
+# define PV_PIPE_INIT_CTRL_PV_INIT_WIDTH_MASK VC4_MASK(11, 8)
+# define PV_PIPE_INIT_CTRL_PV_INIT_IDLE_MASK VC4_MASK(7, 4)
+# define PV_PIPE_INIT_CTRL_PV_INIT_EN BIT(0)
+
#define SCALER_CHANNELS_COUNT 3
#define SCALER_DISPCTRL 0x00000000